This article is pertaining to ER-9, ER-14 and Yaskawa Robots with Linear Slide Base used in FMS / CIM and driven by the USB Pro Controller. The USB Pro Controller may fail to go on-line using Scorbase Pro or Robocell Pro on some PCs running Windows ...
You install Scorbase to operate a physical ER-4U. While Robocell will run the ER-4U it requires licensing that must be purchased. The installation file is the same between the software. Scorbase Robocell
This article can apply to any robot that is operable using recent Windows-based ScorBase or RoboCell versions. For example, an ER-4U, or discontinued robots like the ER-2U, or ER-4PC. Following the steps in this article will allow an operator to ...
RoboCell is simulation software. It is extremely common for users to get confused by the name and think that should run their Robot. The correct software to run the CNC Machine is Scorbase. This software is part of the same installation file.
If your robot at times will randomly not home correctly, please follow the procedure below to ensure proper operation of your robotic system every time. The proper start-up may also resolve the robot moving erratically, disconnect issues Launch ...
If the robot is posed in a position like the picture below the software is in Offline Mode and not in Simulation. How to fix this issue: 1. Goto Options -> Select Simulation. 2. Close and re-open the project.
1. Make sure the robot controller is turned off before opening ScorBase software. Then after the software is open you can go online and home the robot. 2. If the robot still fails to home unplug the large connector from the control box and manually ...